Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Bumpers & Reinforcements
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Bumpers & Reinforcements
I liked the construction of the bracket but have a few suggestions: 1. Holes for mounting should line up with the standard license plate holes. 2. The springs are far too strong. When I tried using self tapping screws to mounts the bracket they pulled out of the bumper facia material (plastic). I had to use larhe nuts, bolts an washers and drill some large holes. 3. Maybe you could provide mounting hardware?
Verified purchase: Yes | Condition: New
Purchased this fold down plate holder bracket for the rear roll pan of my 1992 c1500. This is to hide the winch that sits under the truck, just behind the license plate. This fold down plate holder bracket chipped the paint just behind the hinge area when moved to the folded down position. I had to use 1/2" thick rubber washers behind the mounting holes so the bracket sits about 1/2" proud of the roll pan to allow the hinge to swing back without touching the roll pan paint. As soon as I let go of the plate, the plate flips back up, not allowing me to spool out the winch wire. So I had to fabricate a spring mechanism that holds the plate holder in the open/down position so I can spool out the winch and use it without the plate getting in the way. Otherwise, this fold down license plate holder is okay.Read full review
Verified purchase: Yes | Condition: New
spring loaded hinge holes did not lign up to stock LP holes. I had to bend the sheet metal and force them to fit. Thin sheet metal construction and poor alignment quality. A few millimeters closer together and it would have fit just right. Apparently someone doesn't know the importance of accuracy when it comes to install holes.
Verified purchase: Yes | Condition: New
Exactly what I needed but doesn't clear license plate light, I recommend getting a flush led light. Doesn't work with license plate frames without cutting.
Verified purchase: Yes | Condition: New
I'm happy to report that this plate holder did everything I asked of it. I'm installing it onto a 60 model Ford pickup. I had read an earlier review that said the licsense holes were not correct, also that there those issuesmay be a need for shims to attach it so that it would hinge correctly. I had none of issues. In fact I had no issues at all. I'm very happy that I bought this product and that I bought it here.
Verified purchase: Yes | Condition: New