These fit well, assuming you have the correct engine perch on the frame. 1972 C10 and similar trucks use different perch between small block and big block, they are available online. Originally i had the small block perches and was disappointed. Did have to shave the flanges a little on each head bolt because the Stud kit uses a bit more room. I used a smaller Starter and wrapped the headders nearest to the starter.
Verified purchase: Yes | Condition: New
Headers fit pretty good on my 80 gmc . Clears the frame,starter and the steering . They do sit a little low to the ground . My truck is lowered and I had to raise it up two inches just to drive it . Overall they are definitely good for price and on a stock truck or 4wd they would be great .
Verified purchase: Yes | Condition: New
I installed these headers on a 1979 c10 with a 454 4-spd manual trans , they fit perfectly ...I installed them from underneath without unbolting the motor or removing the starter.....very easy install.....
Verified purchase: Yes | Condition: New
these are awesome. the material thickness in great.
Verified purchase: Yes | Condition: New
I love them, I had a set of Flowtech on the same truck and they lasted for more than 20 years
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Manifolds & Headers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Manifolds & Headers